When the wing of the plane is placed in the air flow direction, due to surface effects, a boundary layer is created near its surfaces. The boundary layer phenomenon affects Airfoil’s performance and has significant effects on the lift and drag coefficients, this phenomenon leads to restrictions that prevent the increase in wing performance. Therefore, in order to achieve optimal conditions, it is necessary to control the formed boundary layer by several techniques. In this paper, by the creation a groove perpendicular to the outstanding edge of the airfoil’s NACA0012, suction flow controlled and the airplane wing performance is investigated in two-dimensional and three-dimensional models and under attack angles and different flow rates. For this purpose, the necessary simulation was carried out using the fluent software, using the K-Kl-ω three-equation turbulence model. The width of the jet (created groove) is %2.5 of the length of the airfoil chord (%2.5C), the location of the groove is %10 of the length of the chord (from the leading edge of the airfoil) and the speed of suction is considered to be half the free speed. The results show that increasing the coefficient of lift can be achieved by creating the suction flow at the wing level and reduced the drag coefficient, which causes a delay the separation of the flow Subsequently, the angles of attack and the appropriate free flow speed rate can be selected to improve the flight of the Unmanned plan.
Dantsker, O. and Moiz, V. "Comparison of Aerodynamic Characterization Methods for Design of Unmanned Aerial Vehicles", 2018 AIAA Aerospace Sciences Meeting, Kissimmee, Florida, USA, 2018.##
Fish, F. E. and Battle, J. M. "Hydrodynamic Design of the Humpback Whale Flipper", J. Morphol., Vol. 225, pp. 51-60, 1995.##
Shan, H., Jiang, L., Liu, C., Love, M., and Maines, B. "Numerical Study of Passive and Active Flow Separation Control Over a NACA0012 Airfoil", Computer.fluid. J., Vol. 37, pp. 975-992, 2008.##
Lam, K. and Lin, Y. "Effects of Wavelength and Amplitude of a Wavy Cylinder in Cross-Flow at Low Reynolds Numbers", J. Fluid. Mech., Vol. 620, pp. 195-220, 2009.##
Luo, H., Qiao, W., and Xu, K. "Passive Control of Laminar Separation Bubble with Span Wise Groove on a Low-Speed Highly Loaded Low-Pressure Turbine Blade", J. Therm. Sci., Vol. 18, pp. 193-201, 2009.##
Do, T., Chen, L., and Tu, J. "Numerical Study of Turbulent Trailing-Edge Flows with Base Cavity Effects Using URANS", J. Fluid. Struct., Vol. 26, pp. 1155-1173, 2010.##
Xie, Y., Chen, J., Qu, H., Xie, G., Zhang, D., and Moshfeghi, M. "Numerical and Experimental Investigation on the Flow Separation Control of S809 Airfoil with Slot", Math. Problem. Eng., Vol. 13, pp 1-14, 2013.##
Livya, E., Anitha, G., and Valli, P. "Aerodynamic Analysis of Dimple Effect on Aircraft Wing", International Journal of Mechanical, Aerospace, Industrial, Mechatronic and Manufacturing Engineering, Vol. 9, no. 2, 2015.##
Wang, Y. "Aerodynamic Effect of 3D Pattern on Airfoil", Transactions of the Canadian Society for Mechanical Engineering., Vol 39, no. 3, pp. 537-545, 2015.##
Brehm C., Mack S., and Gross, A. "Fasel HF Investigations of an Airfoil at Low Reynolds Number Conditions", Proc. Int. Conf. Flow Control, AIAA 2008-3765, Seattle, Washington, 2008.##
Yousefi, K., Saleh, R., and Zahedi, P. "Numerical Study of Blowing and Suction Slot Geometry Optimization on NACA 0012 Airfoil", J. Mech. Sci. Technology., Vol 28, no. 4, pp. 1297–1310, 2014.##
Yousefi, K. and Saleh, R. "Three-Dimensional Suction Flow Control and Suction Jet Length Optimization of NACA 0012 Wing", Meccanica, Vol 50, pp. 1481-1494, 2015.##
Aftab, S., Mohd, K., Razak, N., and Ahmad, K. A. "Turbulence Model Selection for Low Reynolds Number Flows", PLOS One, Vol. 11, no. 4, pp 1-15, 2016.##
Choudhry A., Arjomandi M., and Kelso R., "A Study of Long Separation Bubble on Thick Airfoils and its Consequent Effects", Int. J. Heat. Fluid. Fl., Vol. 52, pp. 84–96, 2015.##
Gad-el-Hak M., "Flow Control: Passive, Active, and Reactive Flow Management", Cambridge University Press, England, 2007.##
Walters, D. K. and Leylek, J. H. "A New Model for Boundary Layer Transition Using a Single-Point RANS Approach", J. Turbomachinery., Vol, 126, pp. 193- 202, 2005.##
Dannenberg, R. E. and Weiberg, J. A. "Section Characteristics of a 10.5 % Thick Airfoil with Area Suction as Affected by Chordwise Distribution of Permeability", NACA Technical Note 2847, 1952.##
Critzos, C. C., Heyson, H. H., and Boswinkle, W., "Aerodynamics Characteristics of NACA0012 Airfoil Section at Angle of Attacks from 0° to 180°", NACA Technical Note 3361, 1955.##
Jacobs, E. and Sherman, A., "Airfoil Section Characteristics as Affected by Variations of the Reynolds Number", NACA Report No.586-231, 1937.##
Ranjbar, M. A., Barkhordari, H., & Mahmodi toroghi, R. (2020). Simulation and Analysis of the Effect of Dimple on the Aerodynamic Performance of Flow Around Drone Wings. Fluid Mechanics & Aerodynamics, 9(1), 17-28.
MLA
Mohammad ali Ranjbar; Houshang Barkhordari; Reza Mahmodi toroghi. "Simulation and Analysis of the Effect of Dimple on the Aerodynamic Performance of Flow Around Drone Wings", Fluid Mechanics & Aerodynamics, 9, 1, 2020, 17-28.
HARVARD
Ranjbar, M. A., Barkhordari, H., Mahmodi toroghi, R. (2020). 'Simulation and Analysis of the Effect of Dimple on the Aerodynamic Performance of Flow Around Drone Wings', Fluid Mechanics & Aerodynamics, 9(1), pp. 17-28.
VANCOUVER
Ranjbar, M. A., Barkhordari, H., Mahmodi toroghi, R. Simulation and Analysis of the Effect of Dimple on the Aerodynamic Performance of Flow Around Drone Wings. Fluid Mechanics & Aerodynamics, 2020; 9(1): 17-28.
)
