Experimental Study of Rheological Behavior of MgO-MWCNT/5W-50 Hybrid Nanofluid: Proposing a New Three-variable Correlation

Document Type : Original Article

Authors

1 emam hosein

2 kashan

Abstract

In the present study, the rheological behavior of hybrid nanofluid (MgO(65%) – MWCNT(35%)/5w50) has been studied. the viscosity of mentioned nanofluid was measured at 5oC- 55oC and 0% – 1% volume fraction range. then the effect of these two parameters on viscosity was studied. Also, the effect of shear rate changes (665.5 s -1 - 11997 s -1 ) on viscosity changes was studied. Fitting power law curves on experimental data and achieve R 2 's with very close to unity was considered as a sign of non-Newtonian behavior of present nanofluid. In order to forecast viscosity quantities as functions of solid volume fraction, temperature, and shear rate, a novel three variable correlation has been proposed (with R 2 =0.999). Viscosity reduction of nanofluid in comparison with the base oil in solid volume fractions of 0.05%, 0.1%, and 0.25% is another remarkable result of the present study.

Keywords


  1. Hemmat Esfe, M., Abbasian Arani, A.A., Rezaie, M., Yan, W.M., and Karimipour, A. “Experimental Determination of Thermal Conductivity and Dynamic Viscosity of Ag–MgO/water Hybrid Nanofluid”, Int. Commun. Heat Mass Transf., Vol. 66, pp. 189–195, 2015.
  2. Hemmat Esfe, M., Saedodin, S., and Mahmoodi, M. “Experimental Studies on the Convective Heat Transfer Performance and Thermophysical Properties of MgO–Water Nanofluid, under Turbulent Flow”, Experimental Thermal and Fluid Science, Vol. 52, pp. 68–78, 2014.
  3. Vakili-Nezhaad, G.R. and Dorany, A. “Investigation of the Effect of Multiwalled Carbon Nanotubes on the Viscosity Index of Lube Oil Cuts”, Chemical Engineering Communications, Vol. 196, No. 9, pp. 997-1007, 2009.
  4. Ettefaghi, E., Rashidi, A., Ahmadi, H., Mohtasebi, S.S., and Pourkhalil, M. “Thermal and Rheological Properties of Oil-Based Nanofluids From Different Carbon Nanostructures”, Int. Commun. Heat Mass Transf., Vol. 48, pp. 178–182, 2013.
  5. Hemmat Esfe, M., Karimpour, R., Abbasian Arani, A.A., and Shahram, J. “Experimental Investigation on Non-Newtonian Behavior of Al2O3-MWCNT/5W50 Hybrid Nano-Lubricant Affected by Alterations of Temperature, Concentration and Shear rate for Engine Applications”, Int. Commun. Heat Mass Transf., Vol. 82, pp.97–102, 2017.
  6. Soltani, O. and Akbari, M. “Effects of Temperature and Particles Concentration on The Dynamic Viscosity of MgO-MWCNT/Ethylene Glycol Hybrid Nanofluid: Experimental Study”, Physica E: Low-dimensional Systems and Nanostructures, Vol. 84, pp. 564-570, 2016.
  7. Zareie, A. and Akbari, M. “Experimental Investigation of Viscosity of MgO-MWCNTs Hybrid Nanofluid in Water-EG Base Fluid”, Modares Mechanical Engineering, Vol. 16, No. 6, pp. 199-204, 2016 (in Persian).
  8. Hemmat Esfe, M., Afrand, M., Yan, W.M., Yarmand, H., Toghraie, D., and Dahari M. “Effects of Temperature and Concentration on Rheological Behavior of MWCNTs/SiO2(20–80)-SAE40 Hybrid Nano-Lubricant”, Int. Commun. Heat Mass Transf., Vol. 76, pp. 133-138, 2016.
  9. Asadi, A., Asadi, M., Rezaee, M., Siahmargoi, M., and Asadi, F. “The Effect of Temperature and Solid Concentration on Dynamic Viscosity of MWCNT/MgO (20–80)-SAE50 Hybrid Nano-Lubricant”, Int. Commun. Heat Mass Transf., Vol.78, pp. 48-53, 2016.
  10. Eshgarf, H., Afrand, M., Hemmat Esfe M. “Experimental Investigation of The Effects of Temperature and Nanoparticles Volume Fraction on The Viscosity of Non-Newtonian Hybrid Nanofluid”, Modarres Mechanical Engineering, Vol. 16, No. 3, pp. 98-104, 2016 (in Persian).
  11. Hemmat Esfe, M., Rostamian, H., and Afrand, M., Wongwises, S. “Examination of Effects of Multi-walled Carbon Nanotubes on Rheological Behavior of Engine Oil (10W40)”, J. Nanostruct, Vol. 6, No. 4, pp. 257-263, 2016.
  12. Hemmat Esfe, M., Afrand, M., Rostamian, S.H., and Toghraie, D. “Examination of Rheological Behavior of MWCNTs/ZnO-SAE40 Hybrid Nano-lubricants under Various Temperatures and Solid Volume Fractions”, Experimental Thermal and Fluid Science , Vol. 80, pp. 384-390, 2016.
  13. Adio, S.A., Mehrabi, M., Sharifpur, M., and Meyer, J.P. “Experimental Investigation and Model Development for Effective Viscosity of MgO–Ethylene Glycol Nanofluids by Using Dimensional Analysis, FCM-ANFIS and GA-PNN techniques”, Int. Commun. Heat Mass Transf., Vol. 72, pp. 71-83, 2016.
  14. Sadri, R., Ahmadi, G., Togun, H., Dahari, M., Kazi, S.N., Sadeghinezhad, E., and Zubir, N. “An Experimental Study on Thermal Conductivity and Viscosity of Nanofluids Containing Carbon Nanotubes”, Nanoscale Research Letters, Vol. 9, No. 151, 2014.
  15. Asadi, M. and Asadi, A. “Dynamic Viscosity of MWCNT/ZnO–Engine Oil Hybrid Nanofluid: An Experimental Investigation and New Correlation in Different Temperature”, Int. Commun. Heat Mass Transf., Vol. 76, pp. 41-45, 2016.
  16. Afrand, M., Najafabadi, K.N., and Akbari, M., “Effects of Temperature and Solid Volume Fraction on Viscosity of SiO2-MWCNTs/SAE40 Hybrid Nanofluid as a Coolant and Lubricant in Heat Engines”, Applied Thermal Engineering, Vol. 102, pp. 45-54, 2016.
  17. Afrand, M., Najafabadi, K.N., Sina, N., Safaei, M.R., Kherbeet,A.Sh., Wongwises. S., and Dahari M. “Prediction of Dynamic Viscosity of a Hybrid Nano- lubricant by an optimal artificial neural network”, Int.